How do you inspect a heating system?

Your heating systems are a fundamental part of your home, and their regular inspections are crucial to identifying potential areas of trouble and resolving them to boost system efficiency. The best way to enjoy home comfort throughout the year is to schedule a biannual service with a trusted heating company like Staton.

What To Expect During An Inspection

Here is a list of the basic steps covered during an inspection:

1. Inspect the chimneys, flues, and vent pipes

A professional technician should inspect the capability and reliability of flues and vents between the equipment and the chimney. Even a tiny inadequacy can lower the efficiency of the heating system and put you at risk. Therefore, this step is crucial.

2. Inspect the carbon-monoxide detector

Almost all modern heating systems contain a carbon-monoxide detector in the internal combustion assembly. It is one of the most significant safeguards in your heating system that ensures your family’s safety. It efficiently detects leakage of any CO inside your home. A heating contractor checks if the detector is undamaged and functioning effectively.

3. Inspect the safety devices

The high-temperature limit switch (which keeps the heating system from getting too hot) and the pressure relief valve should get checked for proper operation. The technician should relight the pilot light as it may have gone out during the summer.

4. Inspect the heat exchanger

The heat exchangers are crucial for efficient heating. The service expert should clean the pilot and main burners and check if the heat exchanger has cracks.

5. Cleaning the interior

Your heating system contains several moving parts and electrical parts. Overtime wear, dirt, and weather can affect the condition of these components, posing a hazard if they do not get checked regularly. During a heating inspection in Alpharetta, your technician checks that all the parts of your heating system are clean and in top condition to eliminate any safety hazards.

6. Inspect air filter condition (for forced-air systems)

Dirty and clogged air filters are a common reason for the reduced efficiency of your heating system. During the inspection, the contractor cleans the filters if necessary. They may also replace the filters to improve system efficiency. If you have a forced-air system, the inspector will also check the condition of the motor and fan for optimal performance.

7. Check the piping and ductwork

The inspector verifies that there is no leakage in the ductwork and that heat is distributed evenly throughout your home. The fuel lines also need to be inspected. In the case of gas systems, the main supply gets checked.

8. Inspect the fuel source

The inspector must verify the adequacy of the fuel source and determine the usability of the tank and the pipelines.

9. Test run

Finally, the technician will perform a test run to check if the entire system is working optimally. The thermostat should read the correct temperature. A good inspector will check a gas system with four different fuels to check the smoke content, flue pressure, the steady-state of the flue gases, and temperature consistency.

Contact Staton For An Inspection Today!

As one of the best providers of HVAC services in Cumming, GA, we help you maximize the efficiency of your heating systems and help you reduce costs on your home heating bill. To know more about our heating system services, contact us today at (770) 746-6727!